0

So I have read this question, Connecting (Anet A8) 2004 display to MKS GEN L.

That looked so easy, so I rewired the connectors and switched the VCC and GND pins. In the Marlin firmware I disabled the MKS GEN L display and enabled the ZONESTAR_LCD and ULTRA_LCD.

Yet when I run the printer, I only get the fully white rectangles. Is there anything else I have to do?

I have a compilation warnings now, because the ZONESTAR_LCD redefines some of the pins that ULTRA_LCD sets, but I guess that is ok. Could it be caused by still including the U8glib library? Do I have to also remove some constant regarding this?

Greenonline
  • 6,748
  • 8
  • 40
  • 68
ezpzlmnsqz1337
  • 121
  • 3

1 Answers1

1

Ok guys I got it! It really was just what is the answer in the other question (Connecting (Anet A8) 2004 display to MKS GEN L)!

My problem was: I used jumper cables and some duct tape to hold them together ... and the only issue was, that I didn't insert it enough. I got mad today and just pushed them really hard more into the AUX2 connector and it suddenly works!

0scar
  • 37,708
  • 12
  • 68
  • 156
ezpzlmnsqz1337
  • 121
  • 3