4

I've recently purchased Anet A8. First print went well, but now, the hot end temperature stays at ~230 °C. When I touch it, it is still cold. I tried the thermistor, and it correctly changes resistance when I blow on it (from 100 kΩ to ~70 kΩ). The voltage in connector is about 300 mV.

Does anybody know what could be wrong?

Greenonline
  • 6,748
  • 8
  • 40
  • 68
honza-kasik
  • 161
  • 5

1 Answers1

2

In my case, I had a bad resistor on my board. R41 had only 2.2 kΩ instead of 4.7. I replaced it and everything works now.

honza-kasik
  • 161
  • 5