7

I am interesting in connecting my RepRap printer to ideaMaker using the same Wi-Fi protocol they use for their Raise3D printers.

Raise3D Wi-Fi protocol

I am sure I could emulate it using a Raspberry Pi if I knew the format of the protocol (I suspect it is pretty simple).

  1. Is the protocol documented anywhere?
  2. Is there open source for something that uses the protocol?
  3. Has anyone that has a Raise3D printer looked at the packets it uses? I suspect the protocol is just G-code in a wrapper.
Greenonline
  • 6,748
  • 8
  • 40
  • 68
markshancock
  • 2,500
  • 2
  • 15
  • 35

1 Answers1

2

OK, I have found the first piece of this puzzle. "The Raise3D printers listen on TCP port 31625 for remote control from ideaMaker."

markshancock
  • 2,500
  • 2
  • 15
  • 35