-1

I purchased it new from Amazon in December. It started about one week ago and it just stops with a constant beep and does not allow me to do anything else except turn it off. Doesn't happen on all prints but just loses its brain.

It does save the printing but I must shut it down manually and then it picks off where it left off but still does the same thing. Printing a bonsai bowl and other things and it goes to 0 °C. Is this something I am doing incorrectly or is it a defect in the unit? To me sounds like a defect.

agarza
  • 1,734
  • 2
  • 16
  • 33
William Richard Cordero
  • 1
  • 1
  • 1

2 Answers2

0

My printer was doing this. I looked all over to try and find a solution on my own. One person said that it was a faulty thermister so having found no other solution I got on the Creality customer support chat and they sent me a file called PID.gcode. I ran the file on the printer and it fixed my issue immediately.

agarza
  • 1,734
  • 2
  • 16
  • 33
Jeremy Matthews
  • 1
-2

Did you check the voltage setting on the back of the unit?

There is a semi-hidden switch that can be flipped to go from 230 volts to 115 volts. If you are in the US, you want to print on 115 volts.

David Fox
  • 1